Easiest Way To Pull Up Carpet Tack Strips

Pull it up cut it into smaller strips if necessary for handling and roll it as you did the carpet.

Easiest way to pull up carpet tack strips.

Remove the carpet padding underneath. Just grab the carpet with pliers and pull. The strips of metal nails under your carpet and carpet padding are called tack strips. To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner.

My husband and i have gotten pretty good at removing carpet 3 different homes and at least 3600 sq ft of it. A very easy way to remove carpet tack strip from the basement concrete floor. After pulling up your carpet you will most likely have tack strips left around the perimeter of the room. Learn how to remove the carpet tack strips and staples in any home by using the best tools for carpet removal.

Pull it up with 10 tools needed to remove carpet. Then grab the carpet by hand and continue to pull it up along an entire wall. Pull one corner of the carpet off the floor. Use the 6 in 1 painter s tool and a hammer to lift one end of one of the strips.

If you can t do this by hand use a carpet claw or a pair of pliers to grip and pull the carpet. Its not that hard with these tips from clay king from aaa flood drying with 28. Some people have a hard time with this step but i ll show you how to remove carpet tack strips the easy way with three simple tools. Removing old carpeting may be necessary to save labor costs if you are having your carpet replaced.

In most cases the carpet padding will also need to be replaced or removed. It should be replaced if it is old or stained or has gotten wet. Carpet removal is a beginner friendly diy project and an easy way to. If you are pulling up carpet from stairs.

You may also need to remove your carpet if you have hardwood floors underneath that you would like to refinish. Begin at the top of the stairs. Fold back about 3 ft. Roll or fold the strip secure with duct tape and remove it from the room.

Carpet padding is usually just stapled down. Pick somewhere to start either a corner or a break between two tack strips. Once you ve lifted the strip closest to the wall enough to get underneath it have a helper cut through the adhesive with a floor scraper while you continue pulling using either the carpet claw or a carpet peeler. If you re removing your old carpet and planning to install new carpet in its place you don t have to remove.

Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips.